Hi Cecilia,

If you have installed it through RPM, the path might have included in to /usr/bin by itself. No need to create path.

It is quite tough to tell where the problem is unless you provide some more information on the version you downloaded, way of installation you did (permission rights), the command shell you are using and the commands you have issued to get this error.

Also, I hope you are not typing "modeller" when issuing the command instead of "mod9.XX"

with kind regards,

lalith

On Fri, Nov 22, 2013 at 6:36 PM, Cecilia Lindgren <cecilia.lindgren@chem.umu.se> wrote:

Hi,

I am completely new to Modeller. I am using Linux and have downloaded and installed the Linux(64-bit x86_64RPM) package, as recommended at the website. I have tried to run scripts from the basic tutorial, but keep getting the following error message:

ImportError: No module named modeller

I have been trying to include the path to modeller in PATH, but have not succeeded. I have python2.7.6 installed.
I would be very grateful if anyone have any ideas of what I can try!

Best regards,
Cecilia

_______________________________________________
modeller_usage mailing list
modeller_usage@salilab.org
https://salilab.org/mailman/listinfo/modeller_usage

--
Lalith Kumar K
Research Associate,
CADD Division,
Dr. Reddy's Institute of Life Sciences (Formerly known as Institute of Life Sciences)
University of Hyderabad Campus
Gachibowli, Hyderabad 500046, India
Tel: +91 9502074040