[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [modeller_usage] Open spline error



My mistake,

Low is defined as "0.05", and not as "0.5"

Regards,
Ignacio

On Fri, Mar 22, 2013 at 5:45 PM, Ignacio Ibarra <" target="_blank">> wrote:
Hello,

When I am defining a distance restraint between heavy atoms through an open spline restraint (open=True) and using restraints.add(), MODELLER writes to console the following message:

"_modeller.ModellerError: mod_res_688E> Incorrect range for open cubic spline     2085,
              dimension        1: xlow (       0.0500) should be less than
              xhigh (       5.0500), and the range should be equal to the
              delta (       0.1200) times the modality (      50) minus 1"

the code line that generates this error is the following:

rsr.add(forms.spline(physical.lennard_jones, features.distance(*atoms), open=True, low=first_step, high=last_step, delta=0.12, lowderiv=0, highderiv=0, values=values, use_array=True))

low = 0.5
high = 5.05
len(values) = 50

I guess that range was calculated internally as xhigh - xmin (5). Given that delta*modality - 1 = 5, I can't guess if the message is an error or not.

Thanks for any advice

Regards,
Ignacio Ibarra