Patches: Difference between revisions

Revision as of 18:23, 5 February 2008

Patches on this page can be applied to Modeller 9v3 to fix some minor problems. (Use the Unix `patch` command, or apply them by hand.)

There are currently no patches available for Modeller 9v3.

Patches for old versions: ["/9v2"] ["/9v1"] ["/8v2"] ["/8v1"]

@@ Line 2: / Line 2: @@
 <!-- #acl [[Modeller Caretaker]]:read,write,revert All:read -->
-Patches on this page can be applied to Modeller 9v2 to fix some minor problems. (Use the Unix `patch` command, or apply them by hand.)
+Patches on this page can be applied to Modeller 9v3 to fix some minor problems. (Use the Unix `patch` command, or apply them by hand.)
-(!) The patches are listed in chronological order (oldest first), so you should apply them in this order to avoid problems.
+There are currently no patches available for Modeller 9v3.
-* [http://salilab.org/modeller/archive/patch-9v2/initial_malign3d.patch initial_malign3d.patch]: make the INITIAL_MALIGN3D option work again with TOP scripts.
-* [http://salilab.org/modeller/archive/patch-9v2/loop_output.patch loop_output.patch]: set OUTPUT correctly so that TOP loop modeling scripts work.
 ----
-Patches for old versions: ["/9v1"] ["/8v2"] ["/8v1"]
+Patches for old versions: ["/9v2"] ["/9v1"] ["/8v2"] ["/8v1"]