[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

FW: Array too small. Increase MPAIRS



------ Forwarded Message
From: quentin kaas <>
Organization: CNRS - IGH
Date: Fri, 14 Mar 2003 15:19:15 +0100
To: 
Subject: Array too small. Increase  MPAIRS

I get a problem when I used Modeller when I do simple optimizations :
"Array too small. Increase  MPAIRS"
I have seen in the archives that it was a problem with older version and I
get 
and install the last version but it still give the same answer... Am I doing
something wrong or is it a source code problem ?

My top file is :

  SET OUTPUT_CONTROL = 1 1 1 1 1

  READ_TOPOLOGY   FILE = '$(LIB)/top_allh.lib'
  READ_PARAMETERS FILE = '$(LIB)/par.lib'
  READ_MODEL FILE = '../../1hsa'
  READ_ALIGNMENT FILE = 'model_MHCp.ali', ALIGN_CODES = '1hsa' 'MHCp'
  GENERATE_TOPOLOGY SEQUENCE = 'MHCp'
  TRANSFER_XYZ
  BUILD_MODEL INITIALIZE_XYZ = off
  WRITE_MODEL FILE = 'MHCp.ini'

  MAKE_RESTRAINTS RESTRAINT_TYPE = 'stereo'
  WRITE_RESTRAINTS FILE = 'MHCp.rsr'
  SWITCH_TRACE TRACE_OUTPUT = 1, FILE = 'MHCp.trc'
  OPTIMIZE OPTIMIZATION_METHOD = 1, MAX_ITERATIONS = 20

  WRITE_MODEL FILE = 'MHCp.B'


Thanks in advance

Quentin Kaas,
IMGT


------ End of Forwarded Message