Without seeing the input/output files, it probably indicates a difficult
optimization problem that runs into many overlapping atom pairs. Can you
improve the alignment?
Andrej
--
Andrej Sali, Professor
Departments of Biopharmaceutical Sciences and Pharmaceutical Chemistry, and
California Institute for Quantitative Biomedical Research
Mission Bay Genentech Hall
600 16th Street, Suite N472D
University of California, San Francisco
San Francisco, CA 94143-2240 (CA 94107 for direct delivery by courier)
Tel +1 (415) 514-4227; Fax +1 (415) 514-4231
Tel Assistant +1 (415)514-4228; Lab +1 (415) 514-4232, 4233, 4239
Email ; Web http://salilab.org
> -----Original Message-----
> From:
> [">mailto:] On Behalf Of Modeller Care
> Sent: Friday, March 14, 2003 6:32 PM
> To:
> Subject: FW: Array too small. Increase MPAIRS
>
>
>
> ------ Forwarded Message
> From: quentin kaas <>
> Organization: CNRS - IGH
> Date: Fri, 14 Mar 2003 15:19:15 +0100
> To:
> Subject: Array too small. Increase MPAIRS
>
> I get a problem when I used Modeller when I do simple
> optimizations : "Array too small. Increase MPAIRS" I have
> seen in the archives that it was a problem with older version
> and I get
> and install the last version but it still give the same
> answer... Am I doing something wrong or is it a source code problem ?
>
> My top file is :
>
> SET OUTPUT_CONTROL = 1 1 1 1 1
>
> READ_TOPOLOGY FILE = '$(LIB)/top_allh.lib'
> READ_PARAMETERS FILE = '$(LIB)/par.lib'
> READ_MODEL FILE = '../../1hsa'
> READ_ALIGNMENT FILE = 'model_MHCp.ali', ALIGN_CODES = '1hsa' 'MHCp'
> GENERATE_TOPOLOGY SEQUENCE = 'MHCp'
> TRANSFER_XYZ
> BUILD_MODEL INITIALIZE_XYZ = off
> WRITE_MODEL FILE = 'MHCp.ini'
>
> MAKE_RESTRAINTS RESTRAINT_TYPE = 'stereo'
> WRITE_RESTRAINTS FILE = 'MHCp.rsr'
> SWITCH_TRACE TRACE_OUTPUT = 1, FILE = 'MHCp.trc'
> OPTIMIZE OPTIMIZATION_METHOD = 1, MAX_ITERATIONS = 20
>
> WRITE_MODEL FILE = 'MHCp.B'
>
>
> Thanks in advance
>
> Quentin Kaas,
> IMGT
>
>
> ------ End of Forwarded Message
>