Hi,all.
I'm new to Modeller. Since I suspect the align result of "align2d()"
function, so I just simple recruited a multiple alignment of a domain
family, and then I create the "*.ali" file by hand.
But when I try to run "automodel" module, and it indicates "E> Sequence
difference between alignment and pdb :".
I'm sure my sequence in the alignment and pdb are the same since I have
succeeded by using the alignment file created by "align2d()" function.
I paste my own alignment below:
>P1;myo10fermA
structureX:myo10ferm.pdb: 197 :A:+213 :A:::-1.00:-1.00
---EMTSTVYCHGGGSCKITINSHTTAGEVVEKLIAGLAMADSANMFALFEYNGHVDKAIESR-TVVADVLAKFE
KLAATSEVGDLP--WKFYFKLYCFLDTDNVPKDSVEFA-FMFEQAHEAVIHGHHPAP-EENLQVLAALRLQYLQG
DYTLH-AAIPPLEEVYSLARLKAR-AAAAEEVS--SARASIIDKWRKF-QGMNQAQAMAKYMALIKEWPGYGSTL
F*
>P1;myo7f
sequence:myo7f: : : : ::: 0.00: 0.00
SKKPIMLPVTFMDGTTKTLLTDSATTARELCNALADKISL-KDRFGFSLYIALFDKVSSLGSGSDHVMDAISQCE
QYAKEQGAQERNAPWRLFFRKEVFTPW-HNPSEDNVATNLIYQQVVRGVKFGEYRCEKEDDLAELASQQYFVDYG
SEMILE------RLLSLVPTYIPDREITPLKN-LEKWAQLAIAAHKKGIYAQRRTDSQ-KVKEDVVNYARFKWPL
L*
And the alignment file created by "align2d()":(This works well with
automodel)
>P1;myo10fermA
structureX:myo10ferm.pdb: 197 :A:+213 :A:::-1.00:-1.00
---EMTSTVYCHGGGSCKITINSHTTAGEVVEKLIAGLAMADSANMFALFEYNGHVDKAIESRTVVADVLAKFEK
LAATSEV--GDLPWKFYFKLYCFLDTDNVPKDSVEFAFMFEQAHEAVIHGHHP-APEENLQVLAALRLQYLQGDY
TLHAAIPPLEEVYSLARLKAR/A/AAAEEVSSARASIIDKWRKFQGMNQAQAMAKYMALIKEWPGYGSTLF*
>P1;myo7f
sequence:myo7f: : : : ::: 0.00: 0.00
SKKPIMLPVTFMDGTTKTLLTDSATTARELCNALADKISLKDRFGFSLYIALFDKVSSLGSGSDHVMDAISQCEQ
YAKEQGAQERNAPWRLFFRKEVFTPWHNPSEDNVATNLIYQQVVRGVKFGEYRCEKEDDLAELASQQYFVDYGSE
MILERLLSLVPTYIPDREITP-L-KNLEKWAQLAIAAHKKGIYAQRRTDSQKVKE--DVVN-YARFKWPLL*
Any advice will be welcome.and Thanks in advance.
Yuan SHANG